Firmware Version 1.0.1 (Build No. 1.0.1_250604)

Release|2025-06-05

New Features and Improvements

---

1. Supports Custom Smart Card of devices connected as slaves.

2. Supports new device connection in CoreStation Setup Manager.

   • Door Interface (DI-24)

3. Supports new device.

   • Door Interface (DI-24)

4. Supports elevator control via the Fire Aux input port.

Bug Fixes

---

1. LED status indicator flashes only in red. 発生バージョン: 1.0.0

2. More than three slave devices can be connected to a single RS-485 port in CoreStation Setup Manager. 発生バージョン: 1.0.0

3. Secure Tamper does not operate in CoreStation Setup Manager when the Use Port is enabled for the AUX port connected to the tamper. 発生バージョン: 1.0.0

4. When the tamper is triggered on the device, the LED light returns to its previous lighting state. 発生バージョン: 1.0.0

5. The default settings for AUX ports (AC Fail, Tamper, Fire) are disabled in CoreStation Setup Manager. 発生バージョン: 1.0.0

6. Authentication fails with a 'period expired' message when using a smart card issued with a visual face included. 発生バージョン: 1.0.0

7. When authenticating with a complex QR code on a device connected as a slave, the card value is not displayed and the event log is incorrectly logged as '1:1 authentication failed(QR/Barcode)'. 発生バージョン: 1.0.0

8. After creating a door on a device configured as a slave and using the slave device's relay for door control, the relay status is incorrectly displayed. 発生バージョン: 1.0.0

9. After rebooting the controller while the door is unlocked due to a fire alarm, the fire alarm is not properly cleared even after clearing the alarm. 発生バージョン: 1.0.0

10. After enabling dual authentication on a door configured with a Wiegand reader, the master device restarts when authentication is performed. 発生バージョン: 1.0.0

11. When the elevator is set to Schedule Unlock, if the RS-485 connection of the slave device is disconnected and then reconnected after the Schedule Unlock ends, the relay does not operate as locked. 発生バージョン: 1.0.0

12. When the time is changed and the Time Synchronization with Server option is enabled, synchronization does not occur immediately but only after a certain period of time. 発生バージョン: 1.0.0

13. After performing Restore to default to Without Network and slave devices are added again, the newly added slave devices are shown as disconnected in the UI, but are actually connected according to the device log. 発生バージョン: 1.0.0

14. Wiegand format card data of 25 bits or less is not recognized. 発生バージョン: 1.0.0

15. When Dual Authentication is set on a door with an OSDP reader, the LED and buzzer operate incorrectly in the waiting-for-input state after the first authentication. 発生バージョン: 1.0.0

16. CoreStation 20 enters an infinite reboot when upgrading the Door Interface firmware after changing the RS-485 port baud rate of CoreStation 20 and Door Interface. 発生バージョン: 1.0.0

17. When a specific device is connected as a slave, configuration changes are not properly applied. 発生バージョン: 1.0.0